Automatic door
operator shall be electromechanical, and
provide for both powered opening and
powered closing of a door. The door
opener shall provide no influence upon
the door except when it is actively
involved with powered opening, holding
open, or closing, thus allowing
unencumbered manual operation.
The unit shall contain aninternal
battery power supply to provide powered
operation in the event of external power
failure. The unit shall be powered by 24
vac, external to the device under
provisions of low voltage wiring and is
supplied with a 40 VA transformer
requiring 115 vac 60 Hz service.
The operator shall be mounted according
to drawings and instructions provided
with each unit. The unit shall be
capable of mounting on either door or
lintel and shall provide door opening
angles up to 180 degrees.
The unit shall possess an adjustable
hold-open feature allowing the door
between 5 and 60 seconds for passage.
The unit shall stop when encountering an
obstruction during an operating cycle at
which time it ceases to provide an
influence on the door.
Operation
Electro-mechanical. Power open,
power close. Automatic clutch
disengagement at all times when not
activated, allowing unimpeded manual
operation.
|
Automatic
open-hold-close cycle (5 to 60 seconds)
activated by a signal from internal
radio receiver or the momentary closure
of electrical contacts provided by wires
to unit.
Automatic cycle may be interrupted by a
signal received within the cycle
bringing the operator into a disengaged
state. Door may be closed remotely if
door is found left open in a non-active
state upon receipt of a signal.
Optional Mode (Auto-Close setting) -
Causes door to close automatically after
a delay upon manual opening. Can be
brought into activation in one of three
ways:
1. Provision of electrical wires to unit
to provide a discontinuity between
internal contacts.
2. Provision of discontinuity of
contacts upon installation.
3. Removal of 24 vac external power to
operator.
Electrical Specifications
Operator:
16-24 vac/dc, 0.01 amp
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 0.03 amp
Battery:
12V DC, 1.2Ah lead acid gel cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply for
Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations
(Programmable)
Dimensions:
2 5/8� x 14 1/8� (Suitable for
mounting with perpendicular wall close
to door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Painted aluminum finish #25
Physical Applications:
Door mounted for inward and
outward opening doors in either
right-hand or left-hand hinged
configurations. (Ceiling clearance 1
1/4� minimum between dooe and ceiling).
Lintel mounted for inward and outward
opening doors in either right-hand or
left-hand hinged configurations.
Activation
Activation may occur by coded signal
from transmitter or by wireless security
entry system. Activation contacts are
provided within unit for remote wired
activation from any device providing
momentary continuity such as touch
plates, push
plates, mats, or infrared motion
sensors.
________________________
Warranty
Open
Sesame Operators and controls are
covered by a one year limited warranty
on materials and internal workmanship.
Our warranty does not apply to services
performed during installation but
technical assistance is available by
calling 1-586-247-8900
________________________
|
