|
Residential Access Packages
| |
|
|
 |
This package will release and open a locked
(or unlocked) door, pause
for entrance or exit, close automatically,
and then return the door to
its locked position. If you would like to
extend the time the door is
open, you can do so by pushing the remote
control again. The door
will stay open as long as you like. To close
the door, simply push the
remote once again. Leaves the door
free-swinging for manual use. |
| |
|
|
|
System II:
Our
System II door opener will release and
open a locked door, pause for entrance
or exit, close automatically, and then
return the door to its locked position.
If you would like to extend the time the
door is open, you can do so by pushing
the remote control again. The door will
stay open as long as you like. To close
the door, simply push the remote once
again.
For extra security, System II can work
with an optional deadbolt function along
with the normally included electric
strike plate door latch release
mechanism. |
Specifications - Door Operator Model 100
(NOTE: Model 200 is identical except
the electromechanical clutch is replaced by
a
non-electrical slipping clutch.)
Automatic door
operator shall be electromechanical,
and provide for both powered opening
and powered closing of a door. The
door opener shall provide no influence
upon the door except when it is
actively involved with powered
opening, holding open, or closing,
thus allowing unencumbered manual
operation.
The unit shall contain an internal
battery power supply to provide
powered operation in the event of
external power failure. The unit shall
be powered by 24 vac, external to the
device under provisions of low voltage
wiring and is supplied with a 40 VA
transformer requiring 115 vac 60 Hz
service.
The operator shall be mounted
according to drawings and instructions
provided with each unit. The unit
shall be capable of mounting on either
door or lintel and shall provide door
opening angles up to 180 degrees.
The unit shall possess an adjustable
hold-open feature allowing the door
between 5 and 60 seconds for passage.
The unit shall stop when encountering
an obstruction during an operating
cycle at which time it ceases to
provide an influence on the door.
Operation
Electro-mechanical. Power open,
power close. Automatic clutch
disengagement at all times when not
activated, allowing unimpeded manual
operation.
|
Automatic
open-hold-close cycle (5 to 60
seconds) activated by a signal from
internal radio receiver or the
momentary closure of electrical
contacts provided by wires to unit.
Automatic cycle may be interrupted by
a signal received within the cycle
bringing the operator into a
disengaged state. Door may be closed
remotely if door is found left open in
a non-active state upon receipt of a
signal.
Optional Mode (Auto-Close setting) -
Causes door to close automatically
after a delay upon manual opening. Can
be brought into activation in one of
three ways:
1. Provision of electrical wires to
unit to provide a discontinuity
between internal contacts.
2. Provision of discontinuity of
contacts upon installation.
3. Removal of 24 vac external power to
operator.
Electrical Specifications
Operator:
16-24 vac/dc, 0.01 amp
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 0.03 amp
Battery:
12V DC, 1.2Ah lead acid gel
cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply for
Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations
(Programmable)
Dimensions:
2 5/8� x 14 1/8� (Suitable for
mounting with perpendicular wall close
to door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Painted aluminum finish #25
Physical Applications:
Door mounted for inward and
outward opening doors in either
right-hand or left-hand hinged
configurations. (Ceiling clearance 1
1/4� minimum between door
and ceiling). Lintel mounted for
inward and outward opening doors in
either right-hand or left-hand hinged
configurations.
Activation
Activation may occur by coded signal
from transmitter or by wireless
security entry system. Activation
contacts are provided within unit for
remote wired activation from any
device providing momentary continuity
such as touch
plates, push
plates, mats, or infrared
motion sensors.
________________________
Warranty
Open
Sesame Operators and controls are
covered by a one year limited warranty
on materials and internal workmanship.
Our warranty does not apply to
services performed during installation. |
|
Open Sesame System I Residential
Package |
|
>>> Free
Shipping On All Automatic Door Openers
<<<
|
|
|
){kind=link}